What would cause a p1351 code?
OBD II fault code P1351 is a manufacturer specific code that most carmakers define as “Ignition Control Module Circuit Voltage”, or sometimes as “Ignition Control Module Circuit High Voltage”….Manufacturer Specific Definitions for P1351.
| Make | Fault Location |
|---|---|
| Ford | Ignition Diagnostic Monitor Circuit Input Fault |
How do I fix my BMW P1345 code?
P1345 Faulty Plug, Coil, or Injector
- Swap ignition coil #2 with the ignition coil from another cylinder.
- Drive for a little and see if the misfire follows to the new cylinder.
- If not, swap spark plug #2 with a spark plug from another cylinder.
- Drive and check if the misfire follows to the new cylinder.
What is ignition Control Module?
The Ignition Control Module is a part of the ignition system. It manages the electrical current that is fed to the ignition coil in order for it to generate the right amount of voltage for the spark-plug to ignite the fuel mixture.
How do you test a Chevy ignition control module?
Clip the negative test light lead to a solid ground such as negative battery terminal. Ask a partner to crank the engine numerous times. The test light should turn on and off as the ignition control module is signaled. If no light is preset, the module is faulty and needs to be replaced.
What does Engine code P1345 mean?
Receiving a P1345 code on your Chevy or GMC vehicle will read out as “Crankshaft Position-Camshaft Position Correlation”. While this error code can be caused by a faulty camshaft position sensor (CMP) or crankshaft position sensor (CPS), the issue a lot of the time relates to engine timing.
What does P0302 mean?
Cylinder 2 Misfire Detected
P0302 is a diagnostic trouble code (DTC) for “Cylinder 2 Misfire Detected”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
Where is the ignition switch module?
The ISM (Ignition Switch Module) is where the key is inserted. The CIM (Column Integration Module) is located inside the steering wheel. It is the security centre and controls the central locking, ignition, immobilisation, steering lock etc.
Where is the ignition module located?
The ignition module may be located inside the distributor, on the distributor housing, or mounted to the side of the engine compartment. When a module goes bad, it normally fails totally and the engine won’t run at all. Checking your ignition module is an easy task that requires only the simplest of tools.