How much power can you get out of a OM617?
| Mercedes-Benz OM617 engine | |
|---|---|
| Power output | 80–230 PS (59–169 kW; 79–227 hp) |
| Torque output | 168–250 N⋅m (124–184 lb⋅ft) |
| Chronology | |
| Successor | OM602 |
How much boost can a OM617 handle?
Turbocharger efficiency: The TB03 turbocharger (48.6/59mm turbine wheel, 0.48 A/R housing) has a reported max boost of 10.3psi which should be reached from about 2500rpm onwards. The turbine maps out as a good fit for ~60% efficiency.
Can you turbo a OM617?
Thanks for any pointers or advice. It can be done and is as easy as just swapping out manifolds and a few oil lines ect but there are differences between the two engines,most noteworthy is the lack of piston oil squirters.
How much does an OM617 weigh?
Registered. sbaert said: IIRC, the stock 617 (naturally aspirated version) weighs about 600Lbs dry without the transmission. Add the trans, and you’re looking at about 750Lbs if not more.
What did the OM606 come in?
The Mercedes-Benz OM606 is a 3.0 litres (2,996 cc) inline-six cylinder (R6/I6) double overhead camshaft (DOHC) diesel engine with indirect injection manufactured by Mercedes-Benz between 1993 and 2001….
| Mercedes-Benz OM606 engine | |
|---|---|
| Manufacturer | Mercedes-Benz |
| Production | 1993–2001 |
| Layout | |
| Configuration | Straight-6 |
How do I uninstall Alda?
Use a 27mm wrench (or 1-1/16″) on the bottom nut and a 24mm wrench (or channel locks) on the ALDA. Turn the nut clockwise and/or the ALDA counter clockwise until the ALDA comes off. That’s it! The shaft visible on the pump has it’s own seal so no oil will get out or dirt in.
What turbo is on om617?
The Holset HX30 has been the turbo of choice on the om617 for quite some time. It has a T3 turbo flange and can bolt directly on the exhaust manifold.
What year is OM606?
The Mercedes-Benz OM606 is a 3.0 litres (2,996 cc) inline-six cylinder (R6/I6) double overhead camshaft (DOHC) diesel engine with indirect injection manufactured by Mercedes-Benz between 1993 and 2001. It replaced the single overhead camshaft (SOHC) OM603 engine.
How many cylinders is a 4BT?
four-cylinder
The acronym, 4BT, means four-cylinder, “B” series turbocharged. It shares many of the same components as the 6BT Cummins, the 12-Valve 5.9L Cummins engine found in the 1st Generation Cummins. In fact, if you take away two cylinders you almost have the same engine.
Does the OM606 have direct injection?
The pre-chambers of the OM606 head will not be present next season, they will be replaced by fitting direct injection nozzles from a Scania. The engine will have a lower compression ratio and more boost will be used, approximately 5 bars.
How much power can a OM606 handle?
Five hundred horsepower
Five hundred horsepower is a threshold for the om606.
How much boost can a OM606 handle?
n/a om606 should be able to do 500hp if you have full boost @ 3000rpm, lower than that and I think you’ll bend the rods (taken from my om604 witch is the same engine just 2cyl shorter and have the same rods). So that number is more or less tested. I did 2.5bar of boost with stock rods and the car was running just fine.