Where are Lyra cartridges made?
Japan
All products are manufactured in Japan with microscopic attention to detail under the direct supervision of these three.
Where is Dynavector made?
Dynavector cartridges are hand made in Japan.
How long do Lyra cartridges last?
Lyra hints that maximum performance requires 30-50 hours, after which the sound smoothes out and noise gets reduced. AudioQuest analog gurus Harley and Shane Buettner corroborate the 30-hour limit. But the cartridge sounds damn good out of the box.
Where are Goldring cartridges made?
Although branded Goldring, the 2400 (and the entire 2000 series) is actually made by Nagaoka in Japan.
How often should I change the stylus on my turntable?
When does a turntable stylus need to be replaced? Most manufacturers recommend changing your stylus at around 1000 hours of record playing time. So if you’re using your turntable for an hour or so per day on average, ideally you should be changing the stylus every couple of years.
Is moving coil better than moving magnet?
They are preferred by audiophiles due to their measurable and subjectively better performance, however. The moving coil cartridge produces a low output level which requires an additional stage of gain to play at sufficient volume.
What is the difference between moving magnet and moving coil cartridges?
Moving magnet designs are heavier than moving coil setups and also exhibit greater inertia when it comes to reading the subtle changes within the grooves. This means that MM designs are less competent at tracking very high-frequency content, and therefore some listeners may feel they lack transient detail.
How often should I replace the cartridge on my turntable?
How do I know if my turntable needs a new needle?
If the needle starts to “skip forward or bounce” it will need to be replaced. Make sure the grip of the Cantilever is solid and not loose. If there is black residue stuck to the point of the needle, it may be a sign that the stylus was overused and not properly maintained.
Is MM or MC cartridge better?
Both cartridge designs can sound excellent but the MC variant has the ability to go one step further and reach audiophile heights. Generally, the best value, lower cost, cartridges are of a MM design. Those who are looking to achieve the best overall sound for turntables often choose the moving coil cartridge.