How do I fix my Razer mouse buttons not working?
Check and download any available firmware updates for your device. Use a can of compressed air to gently blow away any accumualted dirt under the affected button. Test the mouse with a different system without Synapse if applicable. Reset your Razer mouse’s Surface Calibration.
How do I fix my Razer Naga mouse wheel?
Unplug your Razer mouse from the USB port. Turn your mouse upside down so you can see the bottom. Remove all the rubbers tapes attached on the top right and left corner of your mouse. Once it’s removed, you will have a sticky tape that was holding the rubber together, take it off slowly and save it for later.
Why is my Razer mouse sensor not working?
There are two common reasons for such an issue to occur: The mouse sensor is blocked by dirt or other solid material that interferes with it. The mouse needs to reset its surface calibration.
How do I reset my Razer Naga Trinity mouse?
To do this, press and hold the left, middle, and right buttons (M1, scroll wheel, and M2) for 5 seconds. After your mouse resets, you should now be able to reset the surface calibration in Synapse.
Why is my Razer DeathAdder mouse not lighting up?
Unplug your DeathAdder Chroma and use the spare mouse to uninstall Synapse from your computer. Once that’s done, restart your computer before downloading and reinstalling Synapse. Restart your computer again, then plug your DeathAdder Chroma back in.
When I lift my Razer mouse it stops working?
Update Razer Synapse If you are, that could explain the reason behind the Razer Naga freezing up whenever it is lifted. The solution is pretty simple, as updating Razer Synapse and ensuring that there aren’t any problems at all with the software should be enough.
How do I know if my mouse is broken?
If the mouse is an optical or laser mouse, a light should be shining out of the bottom of the mouse if it is turned on. If there is no light, check that it is turned on. If it is and there is still no light, the mouse may be broken.